Skip to main content
F3D
Chỗ để đồ bên hông Prusa Core One (Nam châm 20x5x2) 1

4 images

Máy In 3D

Chỗ để đồ bên hông Prusa Core One (Nam châm 20x5x2)

Remix of Hộp Đựng Bên Hông Cho Prusa Core One By Prusaguy

By MatthewB_2633

Downloads
598
Likes
240
Views
4,668

Files 19 40.3 MB

  • core-one-toolbox-door-v11-a_1766776372.stlSTL · 1.2 MB
  • core-one-box-split-v11-a_1766776373.stlSTL · 2.3 MB
  • core-one-box-split-v11-b_1766776375.stlSTL · 2.4 MB
  • core-one-box-split-v11-c_1766776376.stlSTL · 1.4 MB

Make a variant with AI

Build another version of this model.

Open Studio

Details

Model ID
#179792
Category
Máy In 3D
Published

Description

I found it difficult to source the same 20x6x2 magnets that Prusa uses in the USA, so I remixed the side storage design to accept these 20x5x2 magnets (actual dimensions closer to 18.9 x 4.6 x 1.8 mm).

Required hardware:

I also moved the magnet slots a bit closer to the surface of the model so they stick to the CORE One a bit better. I would like them to stick a little stronger even, but not enough to remix the model again. 🙂

NOTE: Photos show magnets sticking out a bit reference, but the slots are deep enough for them to be fully seated in the printed part.

Along with the remixed files, I've copied the necessary unchanged files from the original model for convenience. In the photos, you'll also see a deeper bottom tray which can be found here.

I printed this with some multicolor painting with MMU3. The attached 3mf file included all the models (except the deeper bottom tray) with the multicolor painting applied.

Onshape link in case you want to remix further.

Thanks to Prusa Guy for the original model AND for providing STEP files so it is easier to remix.

Read more Show less

Print spec

Formats
3mfstepstl
Model files
19
Total size
40.3 MB
Largest file
7.7 MB

0 comments

See all