Kiểm tra Văn bản - Mô hình in 3D

When designing things, you would like to add some form of texts onto your model as an indicator for your object. There are a considerations to be done on adding texts to your parts; what it would look like with such parameters? Printing orientation? How it turned out to be?

This model will be a good test piece for you to test out the emboss/deboss effect that you would like to achieve for your needs and perhaps, for your logo creation as well.

Each line of texts starts at 0.2mm and ends at 1.0mm offset from the plate with 0.2mm steps, except the sixth line. Height of the texts are 5mm.

Printing

It is relatively straightforward, you could have change filament at layer 2 to achieve effects similar to one of the photo above (R-FINDER). And you also can change filament at when the embossed texts started.

Adjust the scaling if you would like to test different texts effect, such as 0.1mm steps or 0.4mm steps.

Do tell me if you have any request on other font family.