Đế Đựng Lon Nhớt V6

i have seen a couple of different approaches to an engine can holder and wanted to give it a go. so here is my design

UPDATED:
it now has a file for cylinders without, the coolant look holes and it can shave about 3 hours of printtime off on my printer, it of course it is depending on your settings

i have designed it so it can be printet on a 220x220mm size bed, you have to adjust the orientation to fit the parts. the cylinders and bottom have heated thread inserts placed into them (m4 thread, 5.4mm outside, sourced on aliexpress), and the sides are screwed on (m4x10mm minimum to reach properly) i placed a heat insert on the inside of the handle too.

i printed it in pla and it holds up just fine.