Skip to main content
F3D
Dụng cụ khóa dây curoa cho KOBRA S1 1

2 images

Máy In 3D

Dụng cụ khóa dây curoa cho KOBRA S1

By Motion_1397550

Downloads
128
Likes
23
Views
1,391

Files 2 277.8 KB

  • BELT_SKIPER_S1_BASE_v5_1766610143.3mf3MF · 123.8 KB
  • BELT_SKIPER_S1_LOCK_v2_1766610144.3mf3MF · 154 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

So the anycubic kobra s1  bed comes terribly leveled out of the box lot of times. This simple tools helps manually level all there bed point ( front left and right and back middle) where frame is connected to z motion system by the way of  belt skipping method.  Whit this method.  This clamp locks the belt in place so you can individually  rotate each lead screw and skip the belt on pullys with out rotating other two lead screw. There for rice and lower each connection point individually. 

FIRST: This calibration method kind of requires Rinkhals overlay to be installed on printer, since looking at bed mesh is needed when performing this bed level calibration. 

https://github.com/jbatonnet/Rinkhalshttps://github.com/jbatonnet/Rinkhals

First you need to fix the BASE in to position like on picture. You can do that by super glue it to base plate  or by drilling two holes in hexagon holes position and using two m3 screws to with hex nut to fix it.  (Caution: Drill in the right holes)

Then you put the belt in the gap on the LOCK and press it in to the groove on the base.

You can secure it with 2 m3 seft taping screw that comes with the printer, but it is not necessary if you press the lock in to the groove enough it should be fix enough.

When calibration is complete you remove only the lock part. Base can stay on printer if you want.

Read more Show less

Print spec

Formats
3mf
Model files
2
Total size
277.8 KB
Largest file
154 KB

0 comments

See all