Chân loa kiểm âm Studio / Chân loa

The printing cost of these should be around 10euro based on the filament price. They are sturdy enough but if you hit the table really hard they will wobble a bit (but wont break or anything) its plastic so this can be expected. 

If I kept the height lower this wouldn't be an issue but I needed to raise the monitors quite a bit, it's around 22 centimetres.

I have been using these since 2021 without issues. Me and my girlfriend bumped into them quite a few times and nothing loosened or fell.

Print Settings :

• Filament tested : I used Pet-G but using PLA should help with the wobbling
• layer height: 0.28mm
• Infill: 30-40%
• Perimeters: 3-4
• Supports: Only for Clamps
• Brim: No

I hope u will enjoy it.