
Kệ đựng giấy in cho Prusa Core One
- Downloads
- 467
- Likes
- 368
- Views
- 4,724
- Remixes
- 1
- Comments
- 0
Files 6 2 MB
- Right_slide_1766471197.stlSTL · 272.5 KB
- Left_slide_1766471198.stlSTL · 461.9 KB
- Right_slide_2mm_1766471200.stlSTL · 246.4 KB
- Left_slide_2mm_1766471200.stlSTL · 459.8 KB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #174323
- Category
- Máy In 3D
- Published
Description
Introductions
I couldn't let the prime estate under the printer go to waste, so here is a print sheet holder that mounts at the bottom and holds four print sheets.
The model utilizes M3 holes in the bottom plate and uses four screws for mounting.
Slots are angled upwards a bit, so the sheets won't fall when shaking during printing.
Required prior modification
This model requires feet to be added to the printer. Compatible models include, but are not limited to:
- Prusa Core One Squash Ball Feet by @dancan13f;
- Prusa core One feet v2 (apart from “angled” versions) by @Prusaguy;
- Prusa core One feet v2 - Squashball Version - Anti Vibration by @TPdesign;
- Models that:
- leave at least 30mm gap at the bottom;
- have xy dimensions similar to this model (it has less than 1cm horizontal gap to the holder).
Required hardware
- 4 M3x4 or longer screws
- rT screws (e.g., M3x4rT) work as well;
- print the
spacermodel if using longer screws (scale it over the Z axis if needed), so they don't stick out into the enclosure.
Print instructions
Models are pre-oriented, so that they can be printed without any supports:
Disclaimer
M3 holes in the bottom plate are an “undocumented feature” of the Core One, so there is no guarantee that they are in the exact same location on all printers. You can validate the holes' position by reorienting the model and printing only the first few layers:
If your holes don't have any threading, you can use slightly longer screws and fix them in place using nuts.
The .step file has a correct relative position, so you can use it to position holes in your own models.
Changelog
2025-09-25 — uploaded version with thicker print sheet slots (2mm instead of 1.5mm)
Print spec
- Formats
- stepstl
- Model files
- 6
- Total size
- 2 MB
- Largest file
- 534.8 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-

-

-

-



