
Ống dẫn PTFE cho bộ che đầu in SE3D Elegoo Centauri Carbon
- Downloads
- 268
- Likes
- 50
- Views
- 1,659
- Remixes
- 0
- Comments
- 0
Files 2 366.9 KB
- toolhead_ptfe_tube_guide_1766409178.3mf3MF · 100.9 KB
- ptfe_tube_guide_assembly_1766409179.stlSTL · 266 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #174151
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
After a few test prints with the new toolhead cover, I noticed that the PTFE tube was rubbing against the glass quite a bit and also tugging and rattling the riser. Loading the filament was also an issue. To counteract this I designed this model. The part is under 2g so it's very lightweight and prints in about 12min.
Print with PETG or ABS/ASA and with supports ON for the countersunk hole.
Installation is simple:
If you already have the toolhead cover installed, just remove the front part of the cover and slide the bottom section of the printed model into place.
Print spec
- Formats
- 3mfstl
- Model files
- 2
- Total size
- 366.9 KB
- Largest file
- 266 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-
New -
New -

-

-
New -
New

