Chân đế điện thoại Fairphone 4

A simple smartphone stand designed to fit the Fairphone 4, but it might also fit other 6,3"-sized smartphones. The geometry is optimized for 3d-printing, therefore no support material and no post-processing is needed. The rest has a slightly wider gap than the thickness of the FP4 if you're using a phone bumper. There's also space to attach a charging plug, however smaller plugs are preferred.

The .3mf-file contains a setup where the base plate is printed with 100% infill to make it heavier than the upper part.

Model designed in Rhino.
Toolpath of the model exported with PrusaSlicer.
Images rendered in Blender/Cycles.

Print Settings

Printer: generic

Rafts: No

Supports: No

Resolution: 0.3 mm

Infill: 25%

Filament: PLA

Notes:

Printing orientation is already set up in the STL-file. You might want to add a small brim for better bed adhesion.