Khuôn Lồng Giữ Kín Dương Vật

This chastity cage is lockable by its own, so it doesnt need an external lock. It comes in many sizes, so it can be fitted to the very penis it is going to lock away. 

Printing:
Print the Cage part on its top side ( you have to rotate it by 180° XorY), all other parts in the given orientation, with all setting as you see fit. No support needed. Using a 0.4 nozzle and 0.2 layerhight is recommended. 
Note: If you print the Cage part in the given orientation, the top side might get a nicer finish, but it needs support for printing in this case.

Using:
After puting on the Ring and the Cage, push the LockPin inside. Make sure the orientation of the pin is correct. If you want to take it off, insert the key and rotate roughly 90deg counter clockwise, while also pushing the pin out with your finger. If the pin is still to far in, use the pointy side of the key for pushing it out.

Done, that’s all :)

Disclaimer:
If you post a make with a tastefull, elegant or kinky picture of its actual use, im going to reserve the right to me, to have this picture added to the main picture repository of this model. So please be aware of this ^^

Looking for something fun to store the Key away in? Maybe have a go with this smal key vault:

Warning: if your balls or penis start to feel slightly cold to the touch, or you observe even little discoloration, immediately take the cage off and have the ring a size bigger! The cage and ring are supposed to sit tight but not that tight. You risk causing severe damage to your body otherwise!