Mount Nhôm Định Hình BTT EBB USB v1

I needed to mount my BTT EBB USB board into my Enderwire and all of the mounts that were available were DIN mounts, so I made one to suit my needs.

This is made from a modified version of the Enderwire's Meanwell RS-25-5 PSU mount.
The "hooked" section slides into the extrusion V slot, and then a single M5 x 10 and M5 T-nut are used to keep the assembly captive.

I've included two variants; one that uses M3 x 4L x 4.5D threaded inserts, and another with no inserts where you screw an M3 into the plastic.

Print Settings

Print out of ASA/ABS using standard Voron print settings. No supports required.

Files & BOM

• 2 * M3 x 4.5D x 4L Heatset Inserts (If using the threaded insert model)

• 2 * M3 x 6 SSBH

• 1 * M5 x 10 SSBH

• 1 * M5 T-nut