
Vành kính thay thế cho đèn pin Streamlight Survivor
- Downloads
- 176
- Likes
- 23
- Views
- 742
- Remixes
- 0
- Comments
- 0
Files 4 5.5 MB
- streamlight_survivor_improved_tpu_1766000542.3mf3MF · 182.8 KB
- Streamlight_Survivor_Lens_Ring_v9_1766000543.f3dF3D · 234.6 KB
- Streamlight_Survivor_Lens_Ring_v9_1766000543.stlSTL · 672.7 KB
- streamlight_survivor_improved_0.15mm_FLEX_MK3SMMU3_1h29m_1766000544.gcodeGCODE · 4.4 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #160454
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
The original lens bezel is prone to break if tightened a bit to hard. This usually happens if the lens does not snap into place and you don't notice it while tightening.
In the original bezel there is a small groove for a rubber o-ring, which is not present in the replacement part i've used from thingiverse. Instead of adding it to the model, i've tried to print it with eSUN eTPU-95A which turned out great.
With my printing settings for that filament there is a bit of stringing and some blobs around the edges, but with a proper heat gun or a simple lighter these can easily be removed.
If you have better print settings, please share them with me, i would be happy to see improvements in the print quality.
The model fits perfectly to the flashlight and with the TPU used i don't worry about the missing o-ring. I'm less worried that this part may break this easily in the future.
The lens protector snaps right into place, you can just re-use it. Or as the original creator of this file mentioned, you can create your own replacement:
If you need to replace the lens as well it is a 52x1 mm clear lens. A possible source for this is recycling a CD Jewel Case.
Print spec
- Formats
- 3mff3dgcodestl
- Model files
- 4
- Total size
- 5.5 MB
- Largest file
- 4.4 MB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-
New -
New -


