
Giá đỡ tua vít cho bảng IKEA Skadis
Remix of Giá đỡ tệp Ikea Skadis By thipilopo_207151
- Downloads
- 63
- Likes
- 9
- Views
- 321
- Remixes
- 1
- Comments
- 0
Files 2 5.5 MB
- screwdriver_holder_1765464768.stlSTL · 2.8 MB
- screwdriver_holder_0.2mm_PLA_MINI_52m_1765464805.gcodeGCODE · 2.8 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #157972
- Category
- DIY
- Published
- License
- Creative Commons — Attribution
Description
I was aiming for as compact model as possible, thus the walls of “funnels” holding screwdrivers are only 1mm thin and spaces between screwdrivers are just big enough so those fit and are nice to take out. Inspired by thipilopo's file holder, however designed from scratch.
Easy to print, only supports were needed for hooks (potentially could cut those down by moving them lower in model). As this is a ±7 gram model, I could not be bothered.
Hooks have small tolerances. Would not recommend not to have them as the hooks like to break when inserted into new Skadis board.
Print spec
- Formats
- gcodestl
- Model files
- 2
- Total size
- 5.5 MB
- Largest file
- 2.8 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-
New -

-
New -
New -

-



