Skip to main content
F3D
Giá đỡ màn hình TFT50 cho Creality Ender S1 1

5 images

Ý Tưởng Khác

Giá đỡ màn hình TFT50 cho Creality Ender S1

Remix of Vỏ BigTreeTech PITFT50 V2 cho Raspberry Pi 4B By loserish

By Arjan

Downloads
148
Likes
21
Views
1,389
Remixes
1

Files 3 1,015.1 KB

  • screen_1764648730.stlSTL · 270.4 KB
  • lid_1764648733.stlSTL · 113.6 KB
  • grille_1764648735.stlSTL · 631.1 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 1

See all 1 remix

Description

This enclosure is designed to house a TFT50 screen with a Raspberry Pi 3B mounted on the back, and it can be easily attached to the Creality Ender 3 S1. To attach the enclosure, you can use the original screws of the stock display.

The design consists of three parts, with the "screen" part being the most important. The other two parts are for the optional back cover, which provides additional protection to the Raspberry Pi and screen. The back cover includes ventilation sleeves to allow for proper airflow and cooling of the enclosed Raspberry Pi and screen. Also there is one bigger sleeve which allows to attach a ribbon cable to the GPIO ports of the Raspberry.

Screen
To install the screen, first mount only this part onto the printer (as shown in the last photo). Then, slide in the display from below. It should fit tightly, so no screws or other fasteners are required.

Back Cover
If you choose to use the back cover, it consists of two parts that should be assembled together tightly. If necessary, sand down the grille or use glue to attach the parts together. After assembling, slightly lift the front of the printer and put the back cover in place. It should fit snugly, and if desired, you can use the four holes to attach it with screws.

Read more Show less

Print spec

Formats
stl
Model files
3
Total size
1,015.1 KB
Largest file
631.1 KB

0 comments

See all