Đĩa đỡ tròn 4 inch cho máy khắc laser XTool F1

This plate accommodates a 4" or about ~101mm round coaster  (wood, metal or Cork) for the XTool F1 laser. (see note about size…)

Note:

> You can print this plate in any filament you want.  (However, a “tough” filament is recommended)
> 15% infill , 3 walls, honeycomb pattern…

> About Size:
By the way, many coasters available online are not truly 4-inches many are 3.89-inches while others are 4.17-Inches. So, I have 2 models available the original one is for ~4-inches+ and the “No-Slack” is for ~4-inches right on the dot. Also, remember that depending on your printer there may be a deviation of 0.5-1mm when printed due to filament shrinking (…etc, etc…)

If you run into any problems, please leave some feedback and I'll try to help out… Thanks!

*********
Other plates / jigs:

Business card -
https://www.printables.com/model/549500-xtool-f1-business-card-plate-jig

Dual leather patch -
https://www.printables.com/model/550853-xtool-f1-leather-patch-plate-jig

8oz flask -
https://www.printables.com/model/552065-xtool-f1-8oz-flask-plate-jig
**********

Like it? , please consider donating the small amount of $1 to help me with development and Design… If you own your own business and are going to use this model in your professional office / workshop / SOHO please consider donating $2 … (via: Ko-Fi ) - Thank You!

********
Looking for more XTool F1 related stuff?
Look at all my models! :)