
DIY
*Ocarina treo cổ nhỏ dạng móc khóa*
- Downloads
- 159
- Likes
- 31
- Views
- 705
- Remixes
- 0
- Comments
- 2
Files 1 8.8 MB
- oc_slide-pendant_1765440790.stlSTL · 8.8 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #155453
- Category
- DIY
- Published
Description
I will publish new Ocarinas only on MakerWorld.
https://makerworld.com/en/@E.CAN3

This is a funny little toy.
So… this ocarina is not in a specific tune.
It is loud and annoying.
It is fun to play.
How to use it:
Close the slot with a finger of your right hand for the lowest note.
Slide your chosen finger to the right to increase the pitch + blow a little bit harder.
Don't block the soundhole on the back!
I print them with:
- 0.4 mm nozzle
- 2 walls
- 0.2 mm Layer hight
- 4 Top and Bottom layers
- Wall Ordering: Outside To Inside - Walls before Infill.
- 20% Infill - Gyroid
- 5mm Brim
- No Support
Important
- Make sure your bed adhesion is good, else it will fail, so… clean your bed before printing!
- Avoid stringing
- Avoid Z-Seam on the labium
- Have fun!
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 8.8 MB
- Largest file
- 8.8 MB
2 comments
You may also like 12 models
See all-

-
New -

-

-

-

-
New -
New -

-

-
New -


