Bộ chuyển đổi màn hình Waveshare cho Qidi X-Max

If you want to switch your Qidi X-Max (1) from the (slightly frustrating) original firmware to Klipper, then the original touchscreen cannot be used anymore. But it is possible to use other touchscreens on your the RaspberryPI (which runs Klipper(screen)). Waveshare has a 5 inch touchscreen with a board which is smaller in width and height. It is therefore ideal to be used together with a self-designed adapter.

Additional materials required:

• 1m or 1.5m (depending on the position of your RPi) DSI/CSI 15 pin flat flex cable (please ping me if you find one with good EMI shielding)
• 8x short M2.5 screws to attach the display to the adapter (should hopefully be delivered with the display)
• use original screws to attach the adapter to the Qidi X-Max chamber

My display (or the Qidi display mounting points) was tilded for me by 0.23 degree. I've compensated this by misaligning the outer holes by 0.25mm. If you want to change this, please open the FCStd and change the Sketch "sk main" for "Pad main".

Please use only heat resistent material - normal PLA will just deform after the chamber warmed up when printing with 120 degree celsius on the heated printbed.

This design is not for X-Max 3 or later

Print Settings

Printer:

Qidi X-Max

Rafts: 

No

Supports:

Yes

Resolution: 

0.2

Infill:

25% Gyroid

Filament:

Polymaker PC-FR

black

Notes:

5 perimeters to make it stiffer

Category: 3D Printer Accessories