Đế Giữ Giấy Nhám / Đĩa Nhám 3"

EDIT 12FEB24: I am not sure when it happened, but all except 4 of the models were corrupted / deleted.  I just re-uploaded them all today, so hopefully that won't happen again.

– – – – – – – – – – – – – – – – – – – – – – – – – – – – – – – 

This is a set of holders for 3" / 75mm Velcro backed sanding pads.

I have previously made a set of holders for 5" disks here and from requests, made them for a bunch of grits. I used that info to make these with all of the requested grits right off the bat, so these are available in the following grit labels:

40, 60, 80, 100, 120, 150, 180, 220, 240, 320, 400, 600, 800, 1.0K, 1.2K, 1.5K, 2.0K, 3.0K, and blank.

This set has "3 Inch" on the holder. If you want "75mm" on the holder, they are located here.

I made them with the corners open on the bottom so I could weight them with sand or lead shot and epoxy, then put some neoprene on the bottom to prevent them from moving around on my bench. I just printed one to try it out, and it looks good, but I may be slightly biased. :-)

Print Settings

Rafts:

No

Supports: 

No

Resolution:

.2mm

Infill: 

20%

Filament: Hatchbox / AMZ3D PLA Red

Category: Tool Holders & Boxes