Skip to main content
F3D
Dụng Cụ Dán Lốp Buggy 2wd
DIY

Dụng Cụ Dán Lốp Buggy 2wd

By JohnBarronII_832531

Downloads
41
Likes
4
Views
337

Files 1 1.4 MB

  • 2wd_Sidewall_Smasher_1766317962.objOBJ · 1.4 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This compresses the sidewalls of your 2wd buggy tire to glue them to the wheel. This is meant to stiffen and shorten the sidewalls. It's primarily used is 2wd buggy offroad carpet racing.

The file only contains one half of the device, but you'll need to print 2 and use 2 M3x10 screws to tighten the two halves together. Even at 100% infill this is less than an hour to print and doesn't cost more than 50 cents in plastic. This way if you strip out one side it's a cheap replacement. Plus, you can print multiple sets to do a whole fleet of tires at once.

Read more Show less

Print spec

Formats
obj
Model files
1
Total size
1.4 MB
Largest file
1.4 MB

0 comments

See all