
Giá đỡ Bình nước nóng cho Vỏ WeMos/LOLIN D1 mini
Remix of Vỏ Hộp WeMos D1 mini By 100prznt
- Downloads
- 15
- Likes
- 1
- Views
- 301
- Remixes
- 0
- Comments
- 0
Files 4 1.1 MB
- temp2iot_WaterHeaterMount_D3_Pajaa_1765658156.STLSTL · 377.6 KB
- temp2iot_WaterHeaterMount_M4_Pajaa_1765658157.STLSTL · 377.6 KB
- temp2iot_D1V4Mount_Pajaa_1765658158.STLSTL · 52.4 KB
- temp2iot_CaseLogoCover_Pajaa_1765658159.STLSTL · 345 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #147375
- Category
- DIY
- Published
Description
The original WeMos D1 mini Enclosure made by 100prznt is such nice component, that I wanted to use it for replacing standard thermometer in my 300L Water Heater tank. So I made accessories for it - the Water Heater Mount. This mount is fully compatible with original parts (after drilling hole for sensor).
The Vater Heater Mount:
Designed for original Dallas Temperature Sensor DS18B20 and space for hiding 1m cable length. Max. cable dia. 4mm.
Mount will slide into plastic flange - flange dia. is 34,8mm (without groves 34mm)
Supporting original cover and two styles of screws:
- the D3 version is for self drilling screws and holes are 3mm dia.
- the M4 version is for M4 Threaded insert e.g. CNC Kitchen (long/short), holes 5,6mm dia.
My printing setup:
Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 100%
Support: Yes
Filament used: 32g
Print time: cca 2:45h
The D1 mount remix:
Designed for Wemos/LOLIN D1 mini V4 version (USB-C). I'm recommending to screw the PCB - so there is preparation for drill the holes based on your preference. Sensor cable has output on the back. You can insert Wemos after sensor soldering, there is 7mm hole - enough for Dallas probe. Try to use some slim USB-C cables.
My printing setup:
Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 25% Gyroid
Support: No
Filament used: 14g
Print time: cca 1:15h
The Cover remix:
The sensor groove was removed from original model
My printing setup:
Material: Prusament PETG
Nozzle diameter: 0.4 mm
Layer height: 0.2 mm
Infill density: 15% Gyroid
Support: No
Filament used: 18g
Print time: cca 1:30h
Print spec
- Formats
- stl
- Model files
- 4
- Total size
- 1.1 MB
- Largest file
- 377.6 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-
New -

-

-

-
New

