Cổng Chặn Bụi / Cổng Chặn / Sperrschieber cho ống HT

Blast Gate for HT pipes

Currently available for:

• DN 75
• DN 50
• DN 40

Available in different lengths:

• DN50: 25mm and 47mm
• DN40: 25mm and 40mm

Available in different versions:

• Do --> outer Diameter of 3D part is 50, i.e. fits into sleeve
• Di --> inner Diameter of 3D part is 50, i.e. pipe fits into 3D part.

Remark:

• any combination within a certain diameter are possible, so also Di_lower with Do_upper, in case one side goes into the pipe, and on the other end, the pipe goes into the part.
• slider and middle are identical for Di and Do versions.

All you need for assembly are:

• 6 M4x16 mm hex head bolts
• 6 M4 nuts
• 6 washers for M4 (optional)

Feel free to support me by donations via Paypal, see link in Bio. - THANKS!

Print Settings

Printer Brand:

Creality

Printer: 

Ender 3

Rafts:

No

Supports: 

No

Resolution:

0.25

Infill: 

20

Filament: Anycubic PLA grey

Notes:

suggested to make a print of a section to check if the tolerances are matching to your print settings. Otherwise you might need to adapt the XY offsets, or scale the part slightly.

Consider at least 3 outer perimeters.

Category: DIY