Chân Máy In XL

This is a super simple replacement foot for the XL printer.

The XL is bigger than the desk I put it on, so it hangs off the edge.  The feet that came with it are hanging in the air and it rests on the plastic clips that cover the wire raceway.  I made these simple feet so I can cantilever the printer over the end of the table and still keep it stable.  I'm sure the purists out there are choking right now, but it's good enough for me!

Made from TPU… there's two gcode files, one with a 15% infill and the other with 50% (or thereabouts).  I made the first one at 15 and it felt too soft and spongy.  I reprinted at 50% and it's pretty firm now.

Note, there's not two code files cause this website keeps yelling at me to tick the exclude time and weight and I did and it still won't let me upload, so I gave up and just did the one at 50%.