Máy Hút Khói Hàn Nhỏ Gọn

This is a compact solder fume sucker. It is made for a 60X60X38 Server fan, but all the dimensions are parameters in Fusion 360. 

No Support Needed! Layer Height 0.3

Non-3D-print Hardware: Requires 8xm3 nuts and bolts, DC jack, Fan. Switch or PWM controller is optional.

I printed most of it in PTEG, but i think only the funnel should be a material than can take a little more heat but it is not necessary. 

When printing wall thickness and infill is not that important. The only thing that is important is when printing the filter holder is if you have a bedslinger. Then the long side should be along the direction the bed moves.

It is made to have a switch and a DC jack for simle use. I might make it more complicate later, but it seemed enough for now.