Glock 43x Grip Plug EDC

Simple little plug for the grip of the Glock 43x. Not much to it. Just follow the instructions.

How Too.

1. Print, in PETG, but pay attention to the way it sits on the print table in your slicers. You must help it. Look at photo. It should sit at an angle.
2. “Make Safe” your Glock 43x
3. It should go into the handle about ¾ the way. The last ¼ is what is going to hold it in. You will have to push it until it is flush. If it is too hard or too easy to get to ¾ the way in, you may need to adjust accordingly. SEE PHOTOS
   1. Note: You might have to adjust the X,Y size in your slicer to get it to slide in.
4. If you want to remove it. Place a simple screw into the hole until it grabs enough for you to be able to pull it out with a pair of pliers.
5. Enjoy. You will shoot so much better with this improvement.