Skip to main content
F3D
Giá Đỡ Filament FilaBilly cho Tủ IKEA Billy 1

2 images

DIY

Giá Đỡ Filament FilaBilly cho Tủ IKEA Billy

By Greenhat_30308

Downloads
1,222
Likes
275
Views
11,762
Remixes
2

Files 3 89.6 KB

  • OtherHolders_1766307432.3mf3MF · 20.8 KB
  • BottomHolder_1766307433.3mf3MF · 19.7 KB
  • SpacerTemplate_1766307434.3mf3MF · 49 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 2

See all 2 remixes

Description

In search of an efficient filament storage solution with limited space, I discovered the potential of the IKEA Billy Bookcase. This guide outlines how to transform it into a filament holder using readily available materials and straightforward assembly steps.

Materials:

  1. IKEA BILLY Bookcase
  2. ½" Electric Metallic Tube (EMT) cut to 29 3/8" (746mm) for the metal dowels (4 x 10-foot pieces) 
  3. #6 x ¾" Pan Head Sheet Metal Screw (x32) for attaching brackets to the bookcase
  4. #8 x 5/8" Pan Head Self-Tapping Screw (x4) for securing EMT Dowel into the holder

Assembly Steps:

  1. Cut 16 pieces of EMT at 29 3/8" (746mm), obtaining four pieces from a single 10-foot EMT.
     
  2. Print the following components (No Supports, .30mm Draft):
    • 2x BottomHolder
    • 14x OtherHolders
    • 1x SpacerTemplate
       
  3. Begin assembly:
    1. Place BottomHolder at the very bottom.

    2. Position the SpacerTemplate on top to center it.

    3. Secure the BottomHolder in place using 2 #6x3/4 screws. Alternatively, use super glue for simplicity (BottomHolders only).

    4. With the SpacerTemplate still in place, add an OtherHolder on top and secure it with #6x3/4 screws. Do not glue. 

    5. Repeat this process, moving upward and using the SpacerTemplate until all OtherHolders are in place.

  4. For the middle shelf, use #8 x 5/8" self-tapping screws to attach the holder to the tube, enhancing the overall rigidity of the bookcase. Refer to notes for an alternative using the Ikea middle shelf.  Screw through the Holder and the metal Tube.
     
  5. Repeat steps 3-4 on the other side of the bookcase.

Notes:

  • Consider using the middle shelf during assembly. The BottomHolder can be placed on the shelf, potentially allowing for the same number of racks. While not tested, measurements suggest it should work.

Future Possibilities:

  • Explore adding doors to the setup to protect filament from moisture.

Read more Show less

Print spec

Formats
3mf
Model files
3
Total size
89.6 KB
Largest file
49 KB

0 comments

See all