Rồng Điêu Khắc (Sculpted Dragon)

This is a basic-sculpted model of a dragon. 

Please note that this is one of my first attempts at modeling using Blender, so please comment or direct messaged me with any way to improve future sculpts and low poly models. I would also love to see any way that you can improve this design by remixing it.

Print Instructions

• Material: PLA
• Supports: Yes
  • At the very least, supports will be required under the wings and chin of the dragon (this is an ideal use case for organic supports)
• Orientation: 
  • Print the model in whatever way minimizes supports
  • If you are using the pin, print it horizontally for the best strength
• Variable Layer Height: Although variable layer height is not required, it improves the quality of the print.

File Variation

• The first variation is the “Normal” one that just contains a completely intact dragon
• The second variation is the “Split” one that contains a cut up version of the dragon that can be glued together
• The third variation is the “Split With Pin” which is basically the same as the last variation, but it has a pin

If you enjoy this model, please leave a like and a comment. If you have any questions, concerns, or problems, please personally contact me.

If you want to support creation of more models like this one, you can subscribe to my Printables Club (at https://www.printables.com/@Devise3D#join:451) or you can purchase an individual model on CGtraitor (at https://www.cgtrader.com/devise3d).