
Công cụ đánh dấu fletching cho mũi tên kiểu dán
- Downloads
- 0
- Likes
- 0
- Views
- 0
- Remixes
- 0
- Comments
- 0
Files 3 69.8 KB
- Arrow_fletching_jig_parametric_1767002900.scadSCAD · 3.4 KB
- Arrow_fletching_marking_jig_parametric_closed_base_1767002900.stlSTL · 33.1 KB
- Arrow_fletching_marking_jig_parametric_open_base_1767002901.stlSTL · 33.3 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #12945
- Category
- Thể Thao & Ngoài Trời
- Published
Description
Why?
This is a small tool made for sliding onto your arrows so you can use a mechanical pencil or marker to draw lines for attaching stick-on type fletchings, such as XSWings, Spin Vanes, Spinwings etc.
Parametric
There are two example STLs included, but the intended use is opening the OpenSCAD file and changing the settings to suit your arrows and preference. All options are editable:
- Arrow shaft diameter
- Outer diameter
- Length of marking grooves
- Width of marking grooves
- Number of marking grooves
- Thickness of support between marking grooves
- Open or closed type base
- Nock aligner height and width
- Length of base before first marking groove starts
There are comments next to each parameter in the .scad file explaining their use.
There is a choice of open or closed type:
Open type is for sliding on from the pile end, where nocks are significantly wider than shaft diameter, or where alignment with the nock direction isn't critical, ie: you have pin nocks and can rotate them to suit afterwards. There is a groove marked in the bottom of the jig if you wish to line up with your nocks anyway.
Closed type is for when you cannot rotate your nocks freely. You can choose to have a nock aligner in the bottom of the jig onto which you push the nock as if it were the string, ensuring correct alignment.
Print spec
- Formats
- scadstl
- Model files
- 3
- Total size
- 69.8 KB
- Largest file
- 33.3 KB
0 comments
You may also like 12 models
See all-

-

-

-
New -

-

-

-

-

-

-

-


