Chân đế và đầu nối được làm lại cho Bệ đỡ module

I liked the overall design, but found the standoffs (or legs) not at all secure and very wobbly so I added additional surface area at the bottom so it had more stability. I also added some tabs at the top so there was 3 point of contact, greatly improving stability.

I also remixed the connector so to add a version that only had two, vice three, pegs. Using a mix of three pegs and two peg connectors is advised, but this way a connector could be used on the outer edges as well as interior edges without a hanging over the plate.