
Sửa nắp chụp cốt dù
- Downloads
- 16
- Likes
- 7
- Views
- 181
- Remixes
- 0
- Comments
- 0
Files 2 1.1 MB
- Umbrella_Cover_Left_Side_v1_1765520795.stlSTL · 505.1 KB
- Umbrella_Cover_Right_Side_v2_1765520808.stlSTL · 612.2 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #128142
- Category
- Đồ Gia Dụng
- Published
Description
This is a cover that encases the crank pulley that opens and shuts the umbrella. The screw holes may need adjusting depending on the screws you use. I printed one test piece of PLA and noticed it does not do well in the sun. I would suggest using ASA, Nylon, PETG, or ABS. I did paint the pieces black after I finished them. The piece is 3 inches in diameter and 5 inches tall. I have included the broken piece as well as the newly printed piece.
UPDATE: So we had a storm. And even though the part I printed was PLA it held up amazing. I am attaching a picture of the wind blown umbrella and you can see the PLA print coupling is still in tact. I was impressed by the strength of the PLA.
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 1.1 MB
- Largest file
- 612.2 KB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-

-

-

-
New -

-
New

