
Vỏ Bảo Vệ Raspberry Pi 5 Tối Giản Dạng Ốp
- Downloads
- 128
- Likes
- 22
- Views
- 914
- Remixes
- 0
- Comments
- 0
Files 1 1.4 MB
- RP5UltraMinimalistSnapOnProtection_1765833924.stlSTL · 1.4 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #123669
- Category
- Dụng Cụ Tiện Ích
- Published
Description
Ultra Minimalist Raspberry Pi 5 snap-on protection base cover.
Easy attaching, quick printing, minimal cover for the bottom of my Raspberry Pi 5 with an active cooler attached. The RP5 has little feet on the bottom to keep the components from contacting things but I didn't want to nick off one of the surface mount components by accident. This cover accomplishes that without adding much bulk.
Based off the reference CAD from Raspberry Pi for an accurate fit.
Installation instructions: (yup)
- Place the memory card edge of Pi on the cover and align the two clips on that side. Squeeze down gently to seat both clips on this side.
- Gently bend the cover between the memory card side and the USB port side to allow the remain two clips to enter the remain holes on the Pi. Gently press them in place and check that that it appears to be well seated in the cover.
Removal instructions: (uh-huh)
- Perform the steps for installation in reverse.
Warning - This case does not provide sufficient protection to allow the use of the Raspberry Pi 5 on an air hockey table.
Hope you like it!
Thanks for the likes and downloads!
…Stay tuned if you like this but want a top half. I'll be adding a super minimalist one soon…
Print spec
- Formats
- stl
- Model files
- 1
- Total size
- 1.4 MB
- Largest file
- 1.4 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-

-

-

-

-
New -

-


