Coaster cho Bình Hoa

There are 2 versions of the Coaster. One with Mouse Ears for printers that struggle with adhesion and one without them.

Important Information

You need to scale the Model to fit the original Vase (Modern spiral planter).

I printed the Vase at 90mm height and used 100% scale.

If you print the Vase at 80mm height, use 90%.

If you print at 70mm height, use 80% and so on…

For bigger Vases like at 100mm height I haven't tested it, but i think from what the pattern tells me it should be 110% then.

Printing

Quality as you like, I used 0.2mm

Supports: No

Brim: not with the Mouse ear Model, for the other Model as you like (personally I don't use it)

The Model with the Mouse ears is to prevent having to remove a brim when having issues with bed adhesion and the corners lifting off. These Mouse ears prevent that issue and are certainly a lot easier to remove that a full brim. Also they use a lot less Material than a normal Brim.

Have fun and I hope the Model helps you :).