Carriage cho Flyingbear Ghost E3D V6 quạt 40mm MK2

I tried to print an old carriage found online but i see that's there are a lot of Issue for printing it.

So i decided to remix myself and convert it to a "Printer Friendly Model" with some improvement.

For mounting it you will need only some M3 screws and nut

Update MK2

Detachable belt fixer plate for an even better printing.

Improvement:

40mm fan mount

dual piece main carriage, easy to print.

improved fan shroud

You will need:

Carriage V2 x1

Hot end mount x1

Hotend block x1

tensioner plate x1

Cover x1

Blower Duct V2 x2

NOTE: Main carriage is the older version where The tensioner plate and the carriage are not splitted, i don't use this for his difficulty to achieve good results without support material.

Print Settings

Printer:

Cargobot MK3

Rafts: 

Doesn't Matter

Supports:

Doesn't Matter

Resolution: 

0.2

Infill:

30%

Filament:

Eryone PETG 

Red gloss

Notes:

Use PETG for better mechanical stress.
Tested with PLA+ and PETG but the last one was better.

Print them sided