
Adapter QuadLock MagSafe kèm vòng TPU
Remix of Bộ chuyển đổi Quadlock sang Magsafe By cnrd_107577
- Downloads
- 53
- Likes
- 4
- Views
- 678
- Remixes
- 0
- Comments
- 0
Files 2 407.2 KB
- TPU_ring_insert_1765811840.stlSTL · 38.4 KB
- Adapter_body_1765811841.stlSTL · 368.8 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #119630
- Category
- Dụng Cụ Tiện Ích
- Published
Description
About
I liked the original model, but found it hard to ‘force’ the MagSafe charging puck into the adapter. Hence I modded it a bit so I could insert a soft TPU ring between the adapter and the charger. It's a better fit and holds well.
Printing
I printed the adapter in PLA-CF, and the ring in TPU 95A (both black). You can use ABS or PLA for the adapter as well. ABS would be a bit stronger and shouldn't warp with this size.
Ring
- Layer height 0.16 or adaptive (advised on Bambu X1C)
- Avoid crossing borders/perimeters
- Print sufficiently slow when printing TPU
- Look at the specs of your TPU and adjust bed and head temperature to be nicely in range
- I used ‘eryone’ TPU and the BAMBU TPU-95A profile
- No supports
Some stringing is normal with TPU, use a sharp knife to remove the strings. If you see extensive stringing, dry your TPU for 9/12h.
Adapter
- Layer height 0.16 or adaptive (advised on Bambu X1C)
- Print with supports
- Use a strong material like PLA-CF, PETG-CF or ABS
- Infill 20% rectilinear
- Border loops 3
Assembly
- Press the TPU ring into the adapter, with the outer ridge downward, so that is retained by the adapter
- Align the slot for the cable
- Press in the apple MagSafe Charger
- Use ;-)
Use
I suggest using the adapter either directly with your phone, or with a phone case that has an additional magnet ring for extra adhesion strength. Using a case without magsafe ring might not hold on bumpy roads.
Disassembly
- Use a wooden or plastic pin (e.g. toothpick) of <3mm diameter to push the magsafe charger puck out of the adapter via the release hole in the rear.
- Take out the adapter and optionally the TPU ring.
Customisation
- Various 3d party magsafe chargers can be fitted by adapting the width of the TPU ring. The including ring fits the official apple charger
Credits
Thanks @cnrd_107577 for the original model!
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 407.2 KB
- Largest file
- 368.8 KB
0 comments
You may also like 12 models
See all-

-
New -
New -

-
New -
New -

-

-
New -
New -

-


