Skip to main content
F3D
Kết nối chân bàn Ikea Lack (không cần vít) 1

5 images

Máy In 3D

Kết nối chân bàn Ikea Lack (không cần vít)

By Phillip

Downloads
48
Likes
10
Views
627

Files 2 125.3 KB

  • Ikea_Lack_Leg_Joiner_1766343101.stlSTL · 14.6 KB
  • Ikea_Lack_Leg_Joiner_1766343102.f3dF3D · 110.7 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

If you make this model and like it, please post your make and rate the model, that would make my day!

I needed to join a cut/open faced Lack leg to the bottom of another leg and I came up with this model.

There's no screws or gluing with this but it does use (free) 30x8mm dowels (part #101350) that you can grab at the Ikea spare parts wall on your way out.

I printed them with the open cavity face down with supports, I did it that way because I didn't want any rough surfaces left over from support material in the narrow gap that might obstruct the fitting of the leg. Maybe it's possible you could print it without any supports with the other face down but I'm not sure, I'm no expert and the slicer was telling me no.

I printed these on a Prusa MK3S+ using the following settings:

  • 0.20mm detail with a 0.6mm nozzle (of course 0.4mm nozzle will be fine)
  • 15% infill
  • 3 perimeters
  • Aligned seams

Read more Show less

Print spec

Formats
f3dstl
Model files
2
Total size
125.3 KB
Largest file
110.7 KB

0 comments

See all