Skip to main content
F3D
Khay Werckmann cho đầu hàn TS-100 của CNCKitchen và ốc ren 1

4 images

DIY

Khay Werckmann cho đầu hàn TS-100 của CNCKitchen và ốc ren

By LucMeister

Downloads
91
Likes
108
Views
2,255

Files 1 769.4 KB

  • wm_ts100_inlay_v2_1765798958.stlSTL · 769.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

This inlay is to compliment my other inlays for Werckmann / Action Store organizer boxes.

I just figured that I never need my CNC Kitchen TS-100 soldering tips without my threaded inserts and vise versa, so I can as well just store them alongside each other.
The inlay for the iron is large enough to store it with any of the tips attached, so if you mainly do M3 you don't always have to (un)screw the tip. The inlays are as raised as they are so they get held by the lid and don't dislocate even when the box is flipped 180°.
There's a little compartment, e.g. for storing an allen key to change the iron on the TS100 directly.

To get the iron out, you just push it down in the rear so it raises in the front, as seen in the photos. There's just very little space and this seemed as an elegant solution to get it out regardless of the size of your fingers.

printing advice.
I printed this at 0.2mm layer height because of all the fillets, but you can get much coarser. Three walls are fine, I used 10% infill which is plenty strong.

Read more Show less

Print spec

Formats
stl
Model files
1
Total size
769.4 KB
Largest file
769.4 KB

0 comments

See all