
Vỏ Raspberry Pi 5 cho Tản nhiệt chủ động
Remix of Vỏ Case Raspberry Pi 5 Tùy Chỉnh By tiramisu
- Downloads
- 53
- Likes
- 1
- Views
- 855
- Remixes
- 0
- Comments
- 0
Files 10 5.9 MB
- Pi5Case_wAC_Button_1765790883.blendBLEND · 940.4 KB
- Pi5Case_wAC_Top_GPIO_1765790884.blendBLEND · 1.1 MB
- Pi5Case_wAC_Bottom_GPIO_1765790885.blendBLEND · 1 MB
- Pi5Case_wAC_Bottom_1765790886.blendBLEND · 1 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #112321
- Category
- Dụng Cụ Tiện Ích
- Published
Description
Remixed modifications with blender.
Printed at 0.2mm and the rear modified “top-to-bottom fastener by the button corner” needed to be cleaned out a bit to get it to slide in the back corner correctly. Had to clean out the air output columns due to the skirt/initial layer. **Update: My pictured print looks pretty bad due to the fact my z-offset was 0.5mm off (note to self, always check z after tramming).
GPIO Versions have NOT been printed/verified yet.
Caveats: It appears to be from the original that the sides don't want to fit flush (even pics from the original show this) and there's a gap on the ethernet header and the board doesn't seat low enough. Ideally it should be fully enclosed so air intake is only through the vents.
The goal was to optimize airflow though I haven't had a chance to compare thermals to verify if it is effective. All files included so if someone wants to make it better, please do!
Print spec
- Formats
- blendstl
- Model files
- 10
- Total size
- 5.9 MB
- Largest file
- 1.1 MB
0 comments
You may also like 12 models
See all-
New -

-

-

-

-

-

-

-

-
New -

-

