
Ống sục khí cho thùng chứa nước
- Downloads
- 19
- Likes
- 1
- Views
- 321
- Remixes
- 0
- Comments
- 0
Files 3 2.4 MB
- Rain_Barrel_Recirculation_Aerator_v7_1765784603.3mf3MF · 473.7 KB
- Rain_Barrel_Recirculation_Aerator_v7_1765784604.f3dF3D · 466.6 KB
- Rain_Barrel_Recirculation_Aerator_v7_1765784605.stlSTL · 1.5 MB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #109713
- Category
- Đồ Gia Dụng
- Published
- License
- Creative Commons — Attribution
Description
I put a 330gal IBC tote (or maybe 275, I can't remember) for water storage at my property. Of course, I did not want it to get stagnant. I put a pump in for moving the water, and then just made a valve setup so when I'm not there, the pump will run on a timer every few hours to cycle the water through this aerator and keep the water moving a little bit. So far it's done pretty good.
You drill a hole in the top of your cistern and put this in, then discharge of the pump goes to the top where I have a ½" barb fitting for vinyl tubing.
Made from PETG but you can do PLA if your cistern is inside like mine. Message me if you want the fusion 360 files.
Print spec
- Formats
- 3mff3dstl
- Model files
- 3
- Total size
- 2.4 MB
- Largest file
- 1.5 MB
0 comments
You may also like 12 models
See all-

-

-
New -

-

-

-

-

-

-

-
New -


