
Bộ chuyển đổi Bong cho Máy hút bụi để bàn
- Downloads
- 15
- Likes
- 2
- Views
- 325
- Remixes
- 1
- Comments
- 0
Files 11 13.8 MB
- MultiSuck_0.3mm_PLA_MK3S_1h46m_1765784223.gcodeGCODE · 4 MB
- Sucky_0.3mm_PLA_MK3S_1h29m_1765784225.gcodeGCODE · 2.4 MB
- MultiSuck_1765784216.stpSTP · 1.4 MB
- MultiSuck_1765784217.stlSTL · 1.2 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #109620
- Category
- DIY
- Published
- License
- Creative Commons — Public Domain
Description
“Multisuck” = tapered inlet to accommodate any reasonable bong with round mouthpiece. A thin rubber lining to the inlet cone might be required. The files for “insert cone” may be needed in order to establish a good seal. There is a cone print for the brave ones, but i recommend printing flat and gluing in place. Use a soft flex material like TPU. You may want a brim on this due to minimal surface area contact (or flip and use supports).
“Sucky” = fits my bong perfectly, requires some random o-ring I had kicking around. requires support material
The “army of small square desktop vacuums” which this fits includes but I'm sure is not limited to “ODISTAR”, “Vishui”, “IGOKOTI”, “TRZLIFE” (Amazon sellers). I based my design on a photogrammetry scan of my unbranded one (xmas gift several years ago). Printed out the concept and it fits perfect. you can remove or retain the filter, i suggest remove, as it impedes suction significantly.
Print spec
- Formats
- gcodepdfstlstp
- Model files
- 11
- Total size
- 13.8 MB
- Largest file
- 4 MB
0 comments
You may also like 12 models
See all-

-

-

-

-

-

-
New -

-

-
New -
New -



