
Hướng dẫn Luồn Dây Tóc Tối Giản Cho Anycubic Kobra
Remix of Hướng Dẫn Dây Tóc Cho Anycubic Kobra By JDBull_265313
- Downloads
- 121
- Likes
- 14
- Views
- 639
- Remixes
- 1
- Comments
- 0
Files 2 1.8 MB
- boltonfilamentguide_solid_1765781196.stlSTL · 843.7 KB
- boltonfilamentguide_slit_1765781197.stlSTL · 1 MB
Make a variant with AI
Build another version of this model.
Remix versions 1
See all 1 remixDetails
- Model ID
- #108905
- Category
- Máy In 3D
- Published
- License
- Creative Commons — Attribution
Description
Remixed version of JDBull's minimal filament guide. I wanted it closer to the spool (and center of the rail) so I mirrored it to other side. I also didn't quite like the slit in the original so I created a solid version as well as created a slit version that adjusted its angle to print a bit better. I also redid the filets in the hole for less friction/drag in both directions - extrusion and retraction.
Print 100% infill with fins facing up.
No supports necessary.
Install by unscrewing stock spool holder arm, placing this underneath (with fins facing down towards build plate), then screwing the arm back down on top of it.
Print spec
- Formats
- stl
- Model files
- 2
- Total size
- 1.8 MB
- Largest file
- 1 MB
0 comments
You may also like 12 models
See all-

-

-
New -

-
New -

-

-

-

-

-

-



