Skip to main content
F3D
Hệ thống bánh xe cho xe đẩy trẻ em 1

6 images

Đồ Chơi

Hệ thống bánh xe cho xe đẩy trẻ em

By kssz2_292468

Downloads
39
Likes
9
Views
433
Comments
2

Files 4 958.5 KB

  • Axle_Support_1767450517.stlSTL · 97.8 KB
  • Axle_Washer_1767450518.stlSTL · 25.1 KB
  • Large_Rim_1767450519.stlSTL · 106.8 KB
  • Large_Tyre_1767450519.stlSTL · 728.8 KB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Wheel system for a child/toddlers push along trolley block cart.

Tyres are overall diameter:  100mm x 21mm
Mags are overall diameter:  77mm x 20mm
(4) Axle supports: 65mm x 60mm
(4) Axle is: M6 x 65mm
(4) Nut is: M6 lock nut
(12) SS Screws approx 20mm

Axle washer is to pull the wheel slightly away from the body of the cart so it wont rub.
Reference to sizing - the cart body is W36cm x L49cm x H12cm

You can use whatever material you want but I used;
Tyre (TPU), Mag Wheel (PLA) and Axle Support (PETG) 
The tyre fits snug over the rim but depending on your settings may need a dab of glue if preferred.

When putting the axle through the rim and wheel support, place the head of the bolt into the hexagon cavity , use a small spanner on the lock nut and turn the wheel as a the hexagon bolt head cavity locks the rim as tightening.

NOTE:
The mag wheel is a ‘heavy’ remix/variation of another I found quite some time ago, but I cannot find it anywhere now to give credit to the original owner. The original was very small and wide.
Tyre is a basic Tinkercad heavily remixed.

Read more Show less

Print spec

Formats
stl
Model files
4
Total size
958.5 KB
Largest file
728.8 KB

2 comments

See all