67 Fidget Toy

How do I feel about this one?? Eh... A bit 6-7 I 'spose 😆

It moves up and down doing the hands thing when you rotate the wheel underneath.

Parts that you will need to print 2x of: Connecting Rod - Drive Wheel Back - Drive Wheel Locator

The back cover is best fixed on using M3 thread heat inserts and screws, but it can be glued on, just be careful not to glue up the mechanism.

The hands just press onto the moving parts, they can be glued but leaving them just pressed on give an failure point if it gets dropped, then they can be simply just pushed back on and the tears stop! 😉

Assembly is pretty easy, the only tricky part is getting the front side connecting rod to locate into the peg on the wheel, but it's not difficult. The square Drive Wheel Joiner goes between the 2 Drive Wheel Back parts to align them.

The numbers need to b e glued onto the hands, there are holes to put a piece of 1.75mm filament into to help align the 2 parts while gluing. I recommend using something like JB Weld for gluing as there isn't much surface area between the 2 parts.