Skip to main content
F3D
Giá đỡ pin Stihl AP 1

4 images

Đồ Gia Dụng

Giá đỡ pin Stihl AP

By Gilles_buildmaster

Downloads
965
Likes
73
Views
3,645
Remixes
2

Files 7 5.3 MB

  • Stihl_AP_battery_pack_holder_single_1766053287.stepSTEP · 414.6 KB
  • Stihl_AP_battery_pack_holder_single_1766053288.f3dF3D · 558.7 KB
  • Stihl_AP_battery_pack_holder_double_1766053289.stlSTL · 1.5 MB
  • Stihl_AP_battery_pack_holder_single_1766053294.stlSTL · 817.4 KB

Make a variant with AI

Build another version of this model.

Open Studio

Remix versions 2

See all 2 remixes

Description

This wall mountable holder should fit all batteries from the AP range (100, 200, 300, 300S). There is a single and a double battery design.

Since these battery packs are expensive and do not like to be in the cold in the winter, I needed to store them in the house somewhere. To make this more convenient I made this battery holder.

It is wall mountable with 4 mm countersunk woodscrews. This is a 'No8' woodscrew in Freedom units. The countersink in the design is such that they remain flush with the plastic and do not scratch the battery pack.

While mounting them, keep in mind the battery sticks out a little bit from the bottom (see picture). When using the double version you should also leave enough finger space to push them out from the bottom. Since you cannot grab a battery comfortably when there are two next to each other.

I added the fusion 360 file and a step file so that you can add some nifty labeling on the front side. Or remix with a coffee cup holder.

If anybody from Stihl reads this, make this a thing I can buy and I will take it offline. You only offer solutions for large numbers of batteries, no love for the hobbyists :-(

This is a copy of my own Thingiverse design.

Read more Show less

Print spec

Formats
3mff3dstepstl
Model files
7
Total size
5.3 MB
Largest file
1.5 MB

0 comments

See all