Skip to main content
F3D
Chậu tự tưới cho chế độ "vase mode" 1

6 images

Đồ Gia Dụng

Chậu tự tưới cho chế độ "vase mode"

By TomasSmolik_1005307

Downloads
50
Likes
10
Views
449

Files 2 27.4 MB

  • self_watering_flower_pot_outer_1765768488.stlSTL · 165.4 KB
  • self_watering_flower_pot_innner_1765768489.stlSTL · 27.2 MB

Make a variant with AI

Build another version of this model.

Open Studio

Description

Self-watering pot for vase mode

This is a project of a self-watering flower pot printable in vase mode (single outline or spiralize).

To print this, you are going to need a wide nozzle, I used 0.8mm, which is sufficient. The wider nozzle will make the pot more sturdy, with this one it holds just fine. If you need a flower pot for outdoor use, I strongly recommend printing this project with UV-resistant filament like ASA.

Print both parts. The original size is 170mm high and 170mm wide when assembled (just enough for your balcony tomato).

Also, check this Extendable funnel for vase mode if you are a lazy gardener like me!

Have fun gardening!

Notes:

When you finish the print make sure that the outer part is watertight. If not, use any water/soil-friendly way to clog any holes.

Read more Show less

Print spec

Formats
stl
Model files
2
Total size
27.4 MB
Largest file
27.2 MB

0 comments

See all