Vỏ Case Pimorony Inky Frame 5.7" có Đế Pin AAA

A snapfit, wallmountable case for the bigger 5.7" Pimoroni Inkyframe with the accessory kit AAA battery holder https://shop.pimoroni.com/products/inky-frame-5-7?variant=40057850331219, otherwise the same as the 4.0" version

The batteryholder inserts with the on-off switch to the back, so I printed this in PETG (you have to wiggle it in place)

Tolerances work for me with a Prusa Mk3s, printed at 0.2mm with Prusament Galaxy Black

Buttons also printed at 0.2mm without supports in the provided orientation as the bridging worked fine, if your printer prints easily removable supports you could do so, just be careful while removing them.

The case has a slot on the back for a flathead screwdriver to lift the back, if needed use the screwdriver to also lift the edges/other sides.

There are screwholes for wallmounting, let me know if it fits the “common” wall screw size (I assumed 6mm dia for the large and 4mm dia for the small hole)

For software check out Kevin J Walters great Instructable: https://www.instructables.com/Battery-Powered-Digital-Picture-Frame-Using-Pimoro/

For more info about the software: https://forums.pimoroni.com/t/inky-frame-slide-show/19996

For another thinner Inky Frame 5.7 case with space for a lipo battery check out: https://www.printables.com/model/314493-inky-frame-case