
DIY
Ván trượt tuyết cho máy bay
- Downloads
- 32
- Likes
- 5
- Views
- 723
- Remixes
- 0
- Comments
- 0
Files 4 2.5 MB
- Apprentice_skies_final_5h7m_0.08mm_210C_PLA_ENDER3_1765757225.gcodeGCODE · 2.4 MB
- Apprentice_skie_front_1765757222.stlSTL · 33.5 KB
- Apprentice_skie_right_1765757223.stlSTL · 32.1 KB
- Apprentice_skie_left_1765757224.stlSTL · 32.1 KB
Make a variant with AI
Build another version of this model.
Details
- Model ID
- #103483
- Category
- DIY
- Published
Description
Filament: PLA
Layer Hight: 0.1-0.08
Print Time: 5h 7m
Used Filament (G): 20
Used Filament (M): N\A
Infill: 5%
Brim: No
Support: Optional
I built these for the apprentice 1.2M but any plane with a wheel rod of 3mm should work fine. You might have to drill ought the holes depending on your printer. They are built to tip back slightly when in the air.
I had to glue pieces of pla to act as stoppers.
Print spec
- Formats
- gcodestl
- Model files
- 4
- Total size
- 2.5 MB
- Largest file
- 2.4 MB
0 comments
You may also like 12 models
See all-

-
New -

-

-

-

-

-

-
New -

-
New -


