Tiêu đề 15mm Đùn M25 Sau Lắp Ráp T-Nut Tóm tắt Một đai ốc c

This is a holder for M2.5 Nuts to create a post assembly installable t-nut for 15mm extrusion, useful for Voron V0 mods. Note that this is tested only on the unknown provenance 15mm extrusion that I have, not Makerbeam XL, so test it with your extrusion before printing a bunch.

To install

Push the M2.5 nut in, then insert the t-nut at an angle into the extrusion slot. You'll need to pop it in with some mild pushing with tweezers or an allen key - it won't simply drop in. Note it's pretty hard to get back out again, so be sure you actually need it before installing.

Prints fine at standard Voron print settings: 0.4mm nozzle, 0.2mm layer height, etc.