Tiêu đề Qidi X-Plus 3 Z-Offset Spacer Tóm tắt Cần thiết cho vòi p

As of this upload diamondback doesn't make a nozzle for this printer. I used a volcano style nozzle which has the same thread but is a few mm too long. To install without damaging your build plate (from experience) I suggest changing the z-offset to at least 2mm over, then install the nozzle and spacer. The spacer is REQUIRED to be able to set the z-offset correctly otherwise it just starts slamming into the build plate even if you set the offset extremely high.

Important: After further testing with the diamond nozzle and this spacer i have found harder/hotter filaments do not print well with it! I was able to get incredible prints running qidi's fast pla however have not had as much success with their abs especially when it comes to larger prints. Feel free to still use it and test it, maybe i just couldn't get the settings quite right but that has been my experience with it thus far!