Tiêu đề Lưu trữ dây tóc - Hỗ trợ Tóm tắt Hỗ trợ sử dụ

This support is for the Freestanding Filament Storage model that was created by @JohnMartin.

I wanted to use the system but found that it moved around too easily when on a flat surface so I wanted something to allow me to slot the rack into and give it a bit of support.

I printed it using the below settings:

• Nozzle: 0.4mm
• Supports: None
• Layer Height: 0.2
• Infill %: 15%
• Infill Type: Gryoid
• Brim: None

Using my BambuLab P1S it took about 35 minutes to print one of these.

All credit goes to @JohnMartin for his great models.