Door hook for coats and jackets

Door hook for coats, jackets or anything you want!

Update 02/12/2023 Added a "V2" design which has the hook angled at appro. 66°. This should make the design a little stronger.

There are two designs:

1 to fit doors of approx. 44.5mm thickness and

1 to fit doors of approx. 35mm thickness.

This hook has been designed to fit my door (44.5mm thick), it can be used in a thinner door but it will be a bit lose and may not work properly.

Very strong and can even hold multiple jackets at the same time with no issues.

I would recommend using a brim as it has the tendency to lift off the bed if you're only using a raft.

Print Settings

Printer Brand:

Creality

Printer:

Ender 3

Rafts:

No

Supports:

No

Resolution:

0.20

Infill:

25%

Filament: eSun PLA Green

Category: Organization