Danh hiệu Người giữ khiên kiếm Tóm tắt KhiênNgười giữ k

Needed a sword holder for my son's room, so I whipped up this model. Tepig is NOT on the downloadable version (if someone wants that, message me and we can work it out).

It is a large print that I did in 1 piece on my Neptune 4 Max. The picture with the 3 samples are printed at 35% scale so it can be made smaller depending on what you will use it to hold. The one sample picture shows both versions with my tests at layer change/colors and the one graphite (partially) rubbed.

2 Versions are available:

Shield_Single - Is the one pictured with the swords. It has a flat back and ‘hooks’ on the front to place the swords (or coats) on. I printed it with 5 perimeter walls to beef up the hooks, 0.20mm layer height, and 10% gyroid infill, no supports needed.

Shield_Bottom & Shield_Top - I did not print a full-size version of this as we went with the “Single” model for our son, however there is a 35% version shown in the one sample pic. These both can also be printed with 5 perimeter walls, 10% gyroid, no supports needed. This one needs glueing together, and you would need to slide the swords down inside after mounting to the wall. Probably not suitable for coats :)