SNOmadic wiper covers

This is a set for 1 wiper blade for a 28" wiper blade. measure your wiper blades before and then divide in 2 and shrink down in the slicer in length not full scale before print.

i would use 5-10% support density to help it have a successful print and easy part cleanup.

in the pics orange part is the main tube. the red slides into the orange for storage when not in use. when using the orange slides over the end of the wiper blade that goes to the passenger side so it would slide over the blade and the red tube. this would help prevent ice from building up around the wiper blade during ice storms while vehicle is parked for a night or days.
i am currently trying to get a set printed. but its going to take to long before deadline of the contest and i just seen this contest was going on yesterday.
my filament to complete a print like this wont be here till the day after on Monday